Enabling Separate Back and Front Designs

Double-sided printing can be used to print the same design on both the front and back sides of the page. It can also be used to print one design on the front of the page, and a different design on the back side. When your item requires a different front and back design, you can set up BarTender to design the two sides separately in different templates.

From the File menu, select Page Setup to open the Page Setup dialog. Alternatively, click the icon on the main toolbar or double-click on a blank area of the template.
Click the Page tab.
Under Template Design Options, enable Separate designs for front and back of item template.
Optionally, check Rotate back side of item template 180. This rotates the design on the back side of the item 180 degrees when it is printed.
Click OK to close the Page Setup dialog.

Once separate designs are enabled, you are ready to design and modify your templates. To modify the front design, select Template (Front) at the bottom of the design area. Similarly, you can access the back design by selecting Template (Back).

When you print the document, BarTender will send both the front and back designs as a single print job. It is not possible to print the front of the item without the back side, and vice versa. To print only one design, you will need to disable the Separate designs for front and back of item template option in the Page Setup dialog.

If you send a document that contains different designs for the front and back to a printer that does not support duplex printing, the front and back designs will print on two separate pages.